Knowledgebase:
BenQ MH740 Projector Correct Setting for RCC183, RCC185 and RCC 187
Posted by Jeremy Littler on 15 October 2015 03:13 PM

BenQ MH740 Projectors  Required Settings following a factory reset (see System Setup below). This is the current recommended approach if  

Note: analog audio is disabled at the Bios level on the Dell PC’s in the podiums

In the event of muted audio apply a factory reset using the BenQ remote. Post factory setup the following settings will need to be verified. The most critical item is to disable Auto Power Off. Also, choose English (if prompted) for language after the projector is re-started.

 

SOURCE:

Quick Auto Search = ON

Color Space Conversion = AUTO

 

SYSTEM SETUP: BASIC: OPERATION SETTINGS

Direct Power = OFF

Signal Power = OFF

Auto Power = Disable (CRITICAL TO SET THIS!)

Quick Cooling = OFF

Instant Restart = OFF

Blank = OFF

Timer = OFF

 

SYSTEM SETUP: ADVANCED (NOTE THE FACTORY RESET OPTION IS IN THIS MENU UNDER RESET ALL SETTINGS)

 

AUDIO:

Mute = OFF

Volume = 9. Use the Vol +/- buttons on the remote to adjust this

Power on/off Ring = ON

 

LAMP MODE:

Lamp Mode = Normal

 

STANDBY:

Network = Off

Monitor Out = On

Audio Pass Through = Disabled

 

LAN:

Wired Lan = OFF

DMX = ON

 

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).