Knowledgebase:
Reset Lexmark Printer to factory Setting
Posted by Reza Fouladgar, Last modified by on 13 February 2014 02:47 PM

1) Turn Off the Printer

2) Press and hold  :  Checkmark  (in the midle) and right Arrow buttoms

3) Turn on the printer and keep holding down the two buttoms explianed above till printer boots up and the menu appears.

4) in the menu choose Factory default setting

 

For the MS610dn series printer (transmedia zone)

 

Hold down 2 & 6 together when the printer is booting up to enter the configuration menu and change printer, network settings etc.

(hold until you see the progress bar) 

*** To reset the admin password on the printer you have to change the jumper on the motherboard in the right side panel (check following link for instructions) ***

http://www.manualslib.com/manual/437151/Lexmark-T650.html?page=321#manual

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).